If you have been following along, you know that I’m trying to get my ShapeOko to be fairly accurate.
One of the tests I’m using is the Circle-Diamond-Square. I ran this test a while ago, and was not very pleased with the results.
I ran it again today. And I’m still not pleased.
It’s better than last time, but the circle is still an egg and the diamond is off a bit too.
But this time I put a square on the square and determined that it’s not square! Aha!
I need to figure out why it’s not square. As far as I can measure, the X and Y axis are reasonably square. Which I guess means I need to figure out a better way to measure it.
So stay tuned.
